0
Van 29 Maart t/m 2 April zijn wij gesloten
0
<< Vorige
|
Home
>
Brodit Proclips en houders
>
Brodit Proffesional
>
Kies hier het merk van uw toestel
>
Panasonic
>
Brodit houder/lader Panasonic Toughbook FZ-L1 fixed instal. Brodit 713101
Brodit houder/lader Panasonic Toughbook FZ-L1 fixed instal. Brodit 713101
Shop op categorie
Brodit houder/lader Panasonic Toughbook FZ-L1 fixed instal. Brodit 713101
Brodit
7320287131017
excl Verzendkosten
Bestel
Beschrijving
Brodit houder/lader Panasonic Toughbook FZ-L1 fixed instal. Brodit 713101
Brodit houder/lader Panasonic Toughbook FZ-L1 fixed instal. With tilt swivel. Use an active holder for your Panasonic while driving and you will always have a freshly charged battery! The active holder is to be connected inside the dashboard. It provides a discreet and neat installation without any cables hanging over the interior. Safe and convenient! 12/24 Volt. The product is E-approved. Connect the power cable with a 2 A fuse. 2 A charger. Charging via pogo plug. Professional installation recommended. Easy-switching system: The easy-switching system enables you to upgrade the holder only, and keep the installed cables. It saves you a lot of time! When upgrading to a new device, you do not longer need to make a full installation. Same goes for maintenance in case of warranty or damage. You simply disconnect the holder from the charging cable via the Molex 6-pin quick connector, and then connect the new holder. The switch is done in a few seconds. The holder is mounted onto a tilt swivel. This mean that you can adjust the angle in order to avoid light reflection on the screen. You can easily switch between portrait and landscape mode by turning the holder into desired position. It is easy to put the unit into place in the holder, and to take it with you when leaving the car. Tablets (Surfpads) should not be installed onto a car’s dashboard if they block the view or block key controls. ProClip (Brodit’s vehicle mounting bracket) is designed for installation of smaller devices like mobile phones and GPS devices, ProClip is not designed for large devices like tablets. In some vehicles the ProClip has an extra firm fit and can then be used also for installation of a tablet. If you want to place a tablet onto the car’s dashboard, each combination of tablet-car must be examined in detail by you in order to determine if such an installation is possible in the specific case. Consideration should be given to the position and how firmly the ProClip is in place, as well as the size of the tablet you wish to use. Brodit will not give any recommendations for such installations. An installation of a tablet onto a vehicle’s dashboard is always done on the customer’s own responsibility. Brodit recommends to use tablets on the car’s headrest, installed onto a Brodit headrest mount. Width: 213 mm Height: 155 mm Depth: 50 mm Volume: 1651 cm³ Weight: 442 g
Klanten die dit product hebben gekocht kochten ook
Snel naar:
Brodit Proclip per auto
Brodit Houders - GSM & Navigatie
Brodit Verstelbare Houders
Brodit Pedestal Mounts
Brodit Proffesional
Brodit Accessoires
Kuda Consoles
Autoradio Inbouwframes
Brodit Telefoonhouder voor op fiets
CarkitStunter.nl
Roerdomp 14
1261 RZ Blaricum
Tel: 035-5237325
info@carkitstunter.nl
Populaire producten:
Bury Carkits
Telefoon Accessoires
Info webwinkel:
Uw Bestelling
Verzending & Bezorging
Ruilen & Retourneren
Voorwaarden
Privacy
Reparatie
Retour adres:
R@s Telecom
Roerdomp 14
1261 RZ Blaricum
!
Mobiele weergave
0
Nederlands (Dutch)